
Vehicle Model: Chery Tiggo 3 (all trims, all model years)
Part Type: Multi-spec fastener clips (plastic buckles) + electrical connector plugs
Widely Applied Positions:
✔ Exterior: Fender, bumper, wheel arch, door panel, hood insulation pad fixing✔ Interior: Dashboard, door trim, ceiling, seat cover, trunk lining fixing✔ Electrical: Wiring harness, sensor, light, audio equipment connecting plugsFitment: 1:1 OEM standard sizing, matches original mounting holes and connection interfaces, no modification required
Installation: Direct snap-in/ plug-in design, no professional tools needed
Material: High-hardness PA66 automotive engineering plastic, reinforced with glass fiber
Performance: High impact resistance, heat/cold resistance (-40°C to 80°C), anti-aging, no brittle cracking
Surface: Smooth burr-free finish, precise snap-in structure for firm clamping without falling off
Shell: High-quality ABS plastic, oil/waterproof, anti-corrosion
Core Pin: Pure copper core with tin plating, low contact resistance, stable electrical conduction
Buckle: Elastic stainless steel snap, firm plug connection, no loose or poor contact
Door panel trim clips
Bumper/fender fixing clips
Wheel arch plastic buckle clips
Trunk/ceiling retainer clips
Hood insulation pad snap clips
2/3/4/6-pin wiring harness plugs
Exterior light connection plugs
Sensor/electrical component plugs
Basic Kit: 50/100 PCS mixed fastener clips (commonly used specs)
Comprehensive Kit: 200 PCS mixed clips + 10 PCS multi-spec connector plugs
Custom Kit: Specify the required clip/plug specs and quantity for customization
Clean the mounting position and remove the residual of the broken original clip.
Align the new clip with the mounting hole, press it firmly until a "click" sound is heard (confirm the clip is fully locked).
Check the fixing tightness, ensure the component is stable without shaking.
Disconnect the power supply of the corresponding electrical component (for safety).
Press the snap of the original plug to pull it out, and remove the wiring harness from the original plug shell (if needed).
Insert the wiring harness into the new plug core pin according to the wiring mark, then install the core pin into the plug shell.
Plug the new connector into the component interface until the snap is locked, and test the component for normal operation.